Gamma 6004 소유자 매뉴얼 - 페이지 16

{카테고리_이름} Gamma 6004에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 6004 20 페이지. 6 point mounting
Gamma 6004에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (19 페이지)

페이지 인쇄

MAINTENANCE and ADJUSTMENTS

machine can accomodate tight string patterns such as badminton. Depending on the string pattern, the clamp may

spread the strings slightly which will not compromise the quality of the string job.

Cam-Lock

Cam-Lock Clamps will need minor adjustments

Cam-Lock

The Cam-Lock

Cam-Lock

according to what string type, construction, and gauge

you are using.

To adjust the gap (clamping pressure) between the

clamp jaws, insert the string through the racquet as if

you were beginning the main strings. Clamp the strings

and pull tension. If the string slips through the jaws of the

clamp, tighten the clamp by compressing the clamp

jaws together by hand while turning the Adjustment

Knob, in the clockwise direction. If the clamp leaves

impressions or damages the string, it may be exces-

sively tight and should be adjusted by turning the hex

Adjustment

Knob

screw counter clockwise to open the gap between the

jaws. The clamp jaws should be cleaned periodically to

be free from dirt, oil, and any string coating for them to

grip properly.

Note: The string clamps supplied with your stringing

Cam-Lock

Clamp Base Adjustment

If the bases of the Cam-Lock clamps slip on the glide

bars, the base locking levers may need adjustment.

Remove the plastic cap by pulling straight up on the

edges of the cap. Line up the large hole in the clamp

base with the smaller hole in the locking cone as shown.

Cam-Lock

Insert the 3MM hex wrench through the holes and into

the screw located in the base. Rotate the wrench

clockwise to tighten the clamp and decrease the base

locking lever travel. Rotate the wrench counterclock-

wise to loosen the clamp and increase the base locking

lever travel.

Clamp Base Adjustment