Gamma 6004 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Gamma 6004에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 6004 20 페이지. 6 point mounting
Gamma 6004에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (19 페이지)

페이지 인쇄

requires the travel permitted by the clamp base. If the travel is not sufﬁ cient to allow smooth

operation adjust the clamp base as outlined on page 16.

to allow for reduced clamping pressure while securing and holding the string under tension.

Note that excessive pressure can damage both the strings and String Clamp.

knob counterclockwise until the "1" or "2" mark on the knob aligns with the line on the knob

support. To decrease tension by 1 or 2 lbs, turn the knob clockwise until the "2" or "1" mark

on the knob aligns with the line on the knob support.

STRINGING THE FRAME

Clamp Base Operation

Rotate the base locking lever clockwise to

secure the clamp base to the turntable.

Reverse the clamping procedure to unlock

the string clamp. The locking lever is spring

loaded to assist the unlocking of the clamp

base.

The locking lever should be tightened enough

to prevent clamp base slippage on the turn-

table, when the desired tension is placed

on the string. To go from the loose position

to the clamped position and back, generally

String Clamp Operation

The String Clamps are of a dual action design

where the string clamp and clamp base oper-

ate independently of one another.

To clamp a string, lift the clamp head and

place the string between the jaws and de-

press the clamp head lever to secure the

string. The clamping pressure applied to the

string should be adjusted to provide sufﬁ cient

pressure to secure the string when subjected

to the desired pulling tension. The diamond

coated gripper plates provide for increased

friction between the clamps and the string

Setting Tension

The spring tensioner utilizes a rotary adjust-

ing knob along with a linear tension scale

to indicate the tension setting. The scale is

divided into 3 lb. increments and each 1/3

turn of the tension knob changes tension

by 1 lb. To set the desired tension, rotate

the tension knob and align the mark on the

spring guide with the desired tension setting

on the scale. When the "0" mark on the knob

aligns with the line on the knob support the

tension will be that indicated on the scale.

To increase tension by 1 or 2 lbs turn the