Gamma 6004 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Gamma 6004에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 6004 20 페이지. 6 point mounting
Gamma 6004에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (19 페이지)

페이지 인쇄

string while tensioning the string. Simply insert the loose end into the tear drop shaped holes

and slide the string toward the point of the hole.

STRINGING THE FRAME

Travel Stop

Setting the Gripper Jaw Spacing

The gripper jaws of the tensioner are adjust-

able to accommodate varying string gauges.

If the string slips through the gripper jaws

while pulling tension, rotate the gripper jaw

adjustment screw counter-clockwise.

If the string is damaged while pulling ten-

sion, rotate the gripper jaw adjustment screw

clockwise.

The jaws will be properly adjusted when there

is enough pressure to securely grip the string

without causing damage to the string.

Tensioner Travel Stop

To prevent contact between the tension head

and the racquet and/or turntable, a travel stop

is located about midpoint along the tensioner

bar below the gear track. In the event the

tension head must be moved closer to the

racquet, pull and turn the travel stop 90 de-

grees. To re-engage the travel stop, simply

pull and turn the travel stop 90 degrees.

Getting Started

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand.

Secure one of the strings using a string clamp.

Handy Tip: The tear drop shaped holes

towards the back of the shoulder supports

are handy for holding the loose end of the