Gamma 7000 Es 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Gamma 7000 Es에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 7000 Es 20 페이지.

ASSEMBLY INSTRUCTIONS

Unpacking the Tensioner

The tensioner assembly is packed and se-

cured to the inner carton by two sheets of

wood and four (4) bolts. With the foam pack-

ing still in place around the base of the

tensioner assembly, remove the inner carton

and lay it on its side on the floor. Remove the

four (4) shipping bolts from the underside of

the carton with a screw driver. Upright the

carton on the floor and remove the tensioner

assembly. Retain the bolts, wood and car-

tons for future shipment.

Foot Installation

CAUTION : To maintain the alignment

between the fiberglass covers and the

frame, it is very important that the feet be

installed before removing the four center

screws that attach the tensioner assem-

bly to the upper post flange.

To install the feet, tilt the tensioner back on its

side and screw the four feet into the holes at

the corners of the base.

Stand Upper Post Installation

After installing the four corner feet, remove

the four (4) button head cap screws and flat

washers from the base of the tensioner.