Gamma Progression ST II 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Gamma Progression ST II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Progression ST II 17 페이지.
Gamma Progression ST II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지)

페이지 인쇄

MAINTENANCE and ADJUSTMENTS

Tension Calibration Procedure

Step 1

Set the tension to 60 lbs. as indicated by the linear scale

and rotary knob. Place the string on one end of a tension

calibrator into a string clamp and secure. Place string

located on the other end of the calibrator into the string

tensioner and apply tension. If the brake lever releases

before 60 lbs. or after 60 lbs., the tension head should

be calibrated as follows.

Step 2

Loosen the 1.5 mm locking set screw (A) located on the

side of the latching block as shown. The set screw is

used to hold the adjustment screw in place.

Step 3

If the lever releases before 60 lbs., using the supplied L-

shaped hex wrench, turn the adjustment screw (C)

located on the left side of the latch block counter-

clockwise to increase the engagement of the brake

release latch with the brake lever. Repeat step 1 and

adjust until the correct tension is indicated on the

calibrator.

If the tension indicated in step 1 is greater than 60 lbs.,

turn the adjustment screw clockwise to reduce the

engagement of the brake release latch with the brake

lever. Repeat step 1 and adjust until the correct tension

is indicated on the calibrator.