Gamma Progression ST II Manual do Proprietário - Página 12
Procurar online ou descarregar pdf Manual do Proprietário para Máquinas de encordoar Gamma Progression ST II. Gamma Progression ST II 17 páginas.
Também para Gamma Progression ST II: Manual do Proprietário (19 páginas)
Imprimir página
MAINTENANCE and ADJUSTMENTS
Tension Calibration Procedure
Step 1
Set the tension to 60 lbs. as indicated by the linear scale
and rotary knob. Place the string on one end of a tension
calibrator into a string clamp and secure. Place string
located on the other end of the calibrator into the string
tensioner and apply tension. If the brake lever releases
before 60 lbs. or after 60 lbs., the tension head should
be calibrated as follows.
Step 2
Loosen the 1.5 mm locking set screw (A) located on the
side of the latching block as shown. The set screw is
used to hold the adjustment screw in place.
A
Step 3
If the lever releases before 60 lbs., using the supplied L-
B
shaped hex wrench, turn the adjustment screw (C)
located on the left side of the latch block counter-
clockwise to increase the engagement of the brake
release latch with the brake lever. Repeat step 1 and
adjust until the correct tension is indicated on the
calibrator.
If the tension indicated in step 1 is greater than 60 lbs.,
C
turn the adjustment screw clockwise to reduce the
engagement of the brake release latch with the brake
lever. Repeat step 1 and adjust until the correct tension
is indicated on the calibrator.
11