Gamma X-6FC 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Gamma X-6FC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma X-6FC 20 페이지.
Gamma X-6FC에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)

ASSEMBLY INSTRUCTIONS

Winder Support Stand Installation

Remove the M5 bolts from the 2 brackets

located in the rear slots of the machine base

using the 5MM hex key. Slide the brackets

to the right end of the base and position the

winder stand over the brackets aligning the

holes in the base of the winder stand with the

holes in the brackets. Attach the winder sup-

port stand using the M5 bolts. Install all 4 bolts

loosely at first and then tighten all securely.

Engaging the Drop Weight Bar Stop

The stringing machine is shipped with the

drop weight bar in the horizontal position. To

limit the rotation of the drop weight bar and

prevent racquet damage during stringing,

the bar stop must be engaged.

Hold the drop weight bar in the vertical posi-

tion as shown while turning the 5mm stop

screw located on the back side of the winder

stand clockwise.

Installing the Drop Weight

Remove the end cap from the tension bar and

slide the drop weight onto the bar. The weight

should be oriented with the knob end closest

to the string winder. Replace the end cap.