Gamma X-ST 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Gamma X-ST에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma X-ST 19 페이지.
Gamma X-ST에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지), 소유자 매뉴얼 (19 페이지)

in the mounting system when the handle is grasped and attempts are made to move it. Should

any supports lose contact with the frame while stringing, they should be re-tightened.

increased friction between the clamps and the string to allow for reduced clamping pressure

while securing and holding the string under tension.

MOUNTING THE FRAME

STRINGING THE FRAME

Securing the Frame Shoulder Clamps

Lock the shoulder supports in position by

turning the knob at the base clockwise.

Repeat the adjustment procedure for the

remaining support post.

Re-tighten all of the frame supports in the

same order as before.

Do not overtighten any of the supports as

racquet damage may occur.

The supports should be tightened to the

point where the racquet frame will not move

String Clamp Operation

The string c

lamps are a dual action design

where the string clamp and clamp base

operate independently of one another.

To clamp a string, lift the clamp head and

place the string between the jaws and

depress the string clamp lever to secure the

string. The clamping pressure applied to the

string should be adjusted to provide suffi-

cient pressure to secure the string when

subjected to the desired pulling tension. The

diamond coated gripper plates provide for

Clamp Base Operation

To lock the string clamp base to the turntable,

rotate the clamp base locking lever clock-

wise. To release the string clamp base from

the turntable, rotate the clamp base locking

lever counter-clockwise.

The Locking Lever should be tightened

enough to prevent clamp base slippage on

the turntable, when the desired tension is

placed on the string. To go from the loose

position to the clamped position and back,

generally requires the rotation permitted by

the slot in th clamp base.