Gamma Borealis R 사용자 설명서 - 페이지 8

{카테고리_이름} Gamma Borealis R에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Borealis R 20 페이지. Led moving wash/beam

DMX Wiring

DMX works by connecting 1 or multiple lights to the output of a DMX lighting console or

software with a DMX interface.

DMX lights connect in what is called a "daisy-chain". Your first DMX cable will plug it's

male DMX connector into the female DMX connector on your lighting console. The re-

maining female connector will then connect to the DMX input on your first light.

You may then connect your next fixture to the output of your first light, and continue the

chain.

32 Fixture Rule – DMX only allows you to connect up to 32 fixtures in a single daisy

chain for signal strength. Sometimes, depending on the fixtures and cable length, this

number is less (or more).

DMX Cables can be 3-pin or 5-pin. These use the same type of data, and in the 5-pin

only pins 1, 2, and 3 are used. The cable should be a 2 conductor, shielded cable of at

least 110 ohms resitance. Microphone cable is not DMX cable.

Borealis R – GAMMA LED Vision

Page 8 of 20