Gamma Luxe Toro 600 RGBW 사용자 설명서 - 페이지 9

{카테고리_이름} Gamma Luxe Toro 600 RGBW에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Luxe Toro 600 RGBW 14 페이지. 600w led spot

DMX Cables can be 3-pin or 5-pin. These use the same type of data, and in the 5-pin

only pins 1, 2, and 3 are used. The cable should be a 2 conductor, shielded cable of at

least 110 ohms resistance. Microphone cable is not DMX cable.

Please refer to the diagram below:

For installations where the DMX cable has to run a long distance or is in an electrically

noisy environment, it is recommended to use a DMX terminator. This helps in preventing

corruption of the digital control signal by electrical noise and reflections. The DMX ter-

minator is simply an XLR plug with a 120 Ω resistor connected between pins 2 and 3,

which is then plugged into the output XLR socket of the last fixture in the chain. Please

see illustrations below:

Luxé Toro 600 RGBAL– GAMMA LED Vision

Page 9 of 14