Gamma Rose XT LED 200 Zoom 사용자 지침 - 페이지 6

{카테고리_이름} Gamma Rose XT LED 200 Zoom에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Rose XT LED 200 Zoom 7 페이지.

3-Pin to 5-Pin Conversion Chart:

Note!

If you use a controller with a 5 pin DMX output connector,you will need to use a 5 pin to 3

pin adapter. The chart below details a proper cable conversion:

Conductor

Ground/Shield

Data(-) signal

Data(+) signal

Not Used

Setting up a DMX Serial Data Link:

Master/Slave Fixture Linking:

1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin

connector of the first fixture.

2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin

connector to the input connector of the next fixture consisting of a (male) 3 pin connector.

Then, proceed to connect from the output as stated above to the input of the following fixture

and so on.

4. DMX Channels Summary

4.1 Operation method

3-Pin to 5-Pin Conversion

3 Pin Female(Output)

Pin 1

Pin 2

Pin 3

5 Pin Male(Input)

Pin 1

Pin 2

Pin 3

Do not use

Led Par Light