Gamma Progression ST II 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Gamma Progression ST II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Progression ST II 19 페이지.
Gamma Progression ST II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (17 페이지)

페이지 인쇄

STRINGING THE FRAME

to allow for reduced clamping pressure while securing and holding the string under tension.

Note: If the string slips in the string clamp while tensioning, adjust the gap between the clamp

jaws per the instructions on page 16.

Note that excessive pressure can damage both the strings and String Clamp.

the slot in the clamp base. If the rotation is not sufﬁ cient to allow smooth operation of, adjust

the Clamp Base Locking Nut as outlined on page 16.

SAtring Clamp Operation

Quick Action Clamps are of a dual action

design where the clamp head and clamp

base operate independently of one another.

To clamp a string, lift the clamp head and

place the string between the jaws and de-

press the clamp head lever to secure the

string. The clamping pressure applied to the

string should be adjusted to provide sufﬁ cient

pressure to secure the string when subjected

to the desired pulling tension. The diamond

coated gripper plates provide for increased

friction between the clamps and the string

Clamp Base Operation

Rotate the Base Locking Lever clockwise

to secure the clamp base to the turntable.

Reverse the clamping procedure to unlock

the string clamp. The Locking Lever is

spring loaded to assist the unlocking of the

clamp base.

The Locking Lever should be tightened

enough to prevent clamp base slippage on

the turntable, when the desired tension is

placed on the string. To go from the loose

position to the clamped position and back,

generally requires the rotation permitted by

Clamping the First Main String

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand.

Secure one of the strings using a string clamp.