Gamma Led Vision TX4 Spot 사용자 설명서 - 페이지 7

{카테고리_이름} Gamma Led Vision TX4 Spot에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Led Vision TX4 Spot 18 페이지. 150w spot moving head

Safety Precautions

This device has left the factory in perfect condition. In order to maintain this condition

and to ensure a safe operation, it is absolutely necessary for the user to follow the safety

instructions and warning notes written in this user manual.

If the device has been exposed to temperature changes due to environmental changes,

do not switch it on immediately. The arising condensation could damage the device.

This light should be keep away from strong shaking during any transportation or

movement.

Don't pull up the light by only the head, or it might cause damages to the mechanical

parts.

Leave the device switched off until it has reached room temperature.

This device falls under protection-class I. Therefore it is essential that the device be

earthed. The electric connection must carry out by qualified person.

The device shall only be used with rate voltage and frequency.

Make sure that the available voltage is not higher than stated at the end of this manual.

Make sure the power cord is never crimped or damaged by sharp edges. If this would be

the case, replacement of the cable must be done by an authorized dealer.

Always disconnect from the mains, when the device is not in use or before cleaning it.

Only handle the power cord by the plug. Never pull out the plug by tugging the power

cord.

During initial start-up some smoke or smell or smell may arise. This is a normal process

and does not necessary mean that the device is defective, it should decrease gradually.

Please don't project the beam onto combustible substances.

Fixtures cannot be installed on combustible substances, keep more than 50cm distance

with wall for smooth air flow, so there should be no shelter for fans and ventilation for

heat radiation.

If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively

replaced by the manufacturer of his service agent or a similar qualified person in order to

avoid a hazard.

TX4 Spot – GAMMA LED Vision

Page 7 of 18