Major Manufacturing HIT-136 사용 설명서 지침

{카테고리_이름} Major Manufacturing HIT-136에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Major Manufacturing HIT-136 6 페이지. Sargent profile series cylindrical locks

페이지 인쇄

SARGENT PROFILE SERIES CYLINDRICAL LOCKS

Remove allen bolt and back plate. Place HIT-136 drill guide on door with aligning washers in the

2-1/8" crossbore. HIT-136 should be placed on door so the writing on the front plate is in the

upright position. Replace back plate and tighten allen bolt until snug. Do not over tighten. HIT-136

is now ready to retrofit Sargent Profile Cylindrical Locks. All through bolt holes may be drilled in

one operation through the door, or half way from both sides. This unit was designed to retrofit

locks with 2-3/4" backsets.

Place alignment washers

on inside of HIT-136 drill

guide in the 2-1/8" lock

crossbore. This is how the

drill guide is aligned.

714-772-5202

FAX 714-772-2302

web: www.majormfg.com

INSTRUCTIONS FOR USE WITH

HIT-136 INSTALLATION TOOL

DRILLING INSTRUCTIONS

Tighten the allen bolt with

the supplied wrench, it

needs to be snug. Do not

over tighten.