Major Manufacturing HIT-136 Instructions For Use Manual

Browse online or download pdf Instructions For Use Manual for Locks Major Manufacturing HIT-136. Major Manufacturing HIT-136 6 pages. Sargent profile series cylindrical locks

Print Page

SARGENT PROFILE SERIES CYLINDRICAL LOCKS

Remove allen bolt and back plate. Place HIT-136 drill guide on door with aligning washers in the

2-1/8" crossbore. HIT-136 should be placed on door so the writing on the front plate is in the

upright position. Replace back plate and tighten allen bolt until snug. Do not over tighten. HIT-136

is now ready to retrofit Sargent Profile Cylindrical Locks. All through bolt holes may be drilled in

one operation through the door, or half way from both sides. This unit was designed to retrofit

locks with 2-3/4" backsets.

Place alignment washers

on inside of HIT-136 drill

guide in the 2-1/8" lock

crossbore. This is how the

drill guide is aligned.

714-772-5202

FAX 714-772-2302

web: www.majormfg.com

INSTRUCTIONS FOR USE WITH

HIT-136 INSTALLATION TOOL

DRILLING INSTRUCTIONS

Tighten the allen bolt with

the supplied wrench, it

needs to be snug. Do not

over tighten.