Major Manufacturing DRILL MASTER HIT-44 소유자 매뉴얼 - 페이지 3

{카테고리_이름} Major Manufacturing DRILL MASTER HIT-44에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Major Manufacturing DRILL MASTER HIT-44 12 페이지. Drill master

HIT-44 ADJUSTMENTS

To adjust for 2-3/8" or 2-3/4"

backset locks, just rotate the

backset knob both on the top

and bottom.

Using the supplied allen

wrench, install the proper

size break out plate/hole saw

guide. Two 1-1/2" and

two 2-1/8" guides are

supplied. For wood door use

mount with the washers on

top of the break out plate.

For steel door use, mount

with the washers under the

break out plate. Remove the

multi-spur guide on opposite

side and replace with

another guide as shown in

picture.

There are three drill guide

bushings supplied with the

HIT-44 for use when drilling

the edge bore, they are

held in with a clip. Choose

from a 7/8", 1" or the brass

guide for use with a multi-

spur bit, they just snap in.