IKEA 705.178.77 매뉴얼 - 페이지 10

{카테고리_이름} IKEA 705.178.77에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA 705.178.77 20 페이지.

ENGLISH

Function

RISING

FAST PREHEAT

- +

SETTINGS

PYRO-CLEANING

MEAT PROBE

*Function used as reference for the energy efficiency declaration in accordance with Regulation (EU) No. 65/2014, Ecodesign for

Energy-Related Products and Energy Information (Amendment) (EU Exit) Regulations 2019.

IMPORTANT:

During the self-clean cycle (pyrolysis) make sure to remove all

the accessories supplied, to prevent any further increase in the

outside temperature of the door and to ensure more efficient

cleaning of the bottom part of the oven.

Description of function

For optimal rising of sweet or savoury dough. To safeguard the quality of proving, the function will

not activate if the temperature in the oven is above 40°C. Place the dough on the 2nd shelf.

The oven does not have to be preheated.

To preheat the oven rapidly. At the end of the prehear the oven will select automatically the

CONVENTIONAL function. Wait the end of the preheat before inserting te food inside the oven.

To set the display (Time, Light, Volumes of sounds, energy saving).

For eliminating cooking spatters using a cycle at a very high temperature (over 400 °C). The

duration is automatically set to 120 minutes. Select ECO x 75minutes cycle in case of minor

presence of dirt.

The meat probe supplied allows the exact temperature (up

to 100°C) to be measured during cooking, to ensure optimum

cooking.

Based on the food being cooked, the required core

temperature can be set. It is very important to position the

probe accurately in order to obtain perfect cooking results.

Insert the probe fully into the fleshiest part of the meat,

avoiding bones and fatty parts (Fig. 1). For poultry, the probe

should be inserted sideways, in the middle of the breast,

taking care to ensure the tip does not end up in a hollow

part (Fig. 2). In the case of meat with very irregular thickness,

check it is cooked properly before removing it from the oven.

Connect the end of the probe in the hole located on the left

bottom part of the control panel.

IMPORTANT: if the function selected is not matching the meat

probe use, cooking will not start until the probe is removed. A

following message is displayed: REMOVE PROBE.

Fig. 1

Fig. 2