Major tech MT155 사용 설명서 - 페이지 3
{카테고리_이름} Major tech MT155에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Major tech MT155 8 페이지. Coating thickness meter
페이지 인쇄
Tester Layout
1.
LCD display
2.
Select key: For ON/OFF, SELECT and OK
3.
Up key: For upward selection and working mode switch
4.
Clear Key: Calibration Zone of the FE and NFE
5.
Housing
6.
Back Key: For return or to delete the last measured data
7.
Down key: For downward selection or working mode switch
8.
Probe
9.
Battery cover
Ready to Start
Power on:
Press and hold the POWER button. If the LCD display does not switch on,
check if the battery is correctly installed or flat.
Displayed:
Low battery, replace battery immediately. The gauge will take faulty
measurements if the voltage is low.
Note: When the power is on, keep away from any metal at least 10cm away
before each measurement, zero calibration is recommended.
Inserting/Replacing Batteries
1.
Switch off the tester, remove the battery cover and remove batteries.
2.
Insert new batteries, observing correct polarity and close the cover.
•
Replace the batteries when the symbol "
•
Use alkaline batteries only.
•
Remove the batteries before any long period of non-use to avoid the
danger of corrosion.
Function & Operation Instruction
•
Press the
O
work in measuring mode.
•
Press the SELECT button to enter the MENU mode.
1
2
3
4
5
button to switch on the power. The gauge will automatically
9
6
7
8
.......
" is displayed.