Centurion SMART GUARD air 사용 설명서 - 페이지 2

{카테고리_이름} Centurion SMART GUARD air에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Centurion SMART GUARD air 12 페이지. High security keyless access control
Centurion SMART GUARD air에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지)

페이지 인쇄

1. KwikLearn

In order to preserve battery life, the unit is packed with the link

fitted on the 12V side of the power selection pins.

To select batteries as the primary power source, bridge

the pin marked 'AA BATT' with the common (centre) pin.

For information on selecting 12V as the primary power source,

refer to Section 19, 'Typical connection diagram'.

The following KwikLearn procedure and connection diagram will enable

you to start using your SMARTGUARDair system right away.

Additional procedures are explained later in this guide.

Add a new access code at a specified address.

The code will operate Channel 1 only.

In the example below, a new code is learned into Address 0,

meaning that a new Master Code will be created and the existing

Master Code replaced.

Enter the following keystrokes:

1. Enter Program Mode

2. Select KwikLearn

3. Enter user address

4. Enter access code

Default Master Code=1234

The SMARTGUARDair will have to be paired to a valid receiver

before a code will be able to activate it. Thus, the KwikLearn

procedure will store a new code in the keypad's memory, but the

code will still have to be associated with a receiver using either the

KwikPair facility described overleaf, or the Pairing Menu (Menu 3).

Example:

Kwiklearn access code

Master Code=

Enter the following keystrokes:

1. Enter Program Mode

2. Select KwikLearn

3. Enter user address

4. Enter access code

2.KwikPair

The SMARTGUARDair must now be paired with a CENTURION

code-hopping radio receiver.

Place the receiver into Learn Mode, and enter a valid code on the

SMARTGUARDair, followed by

now transmit for a short time, and will pair with the receiver.

Remove the receiver from Learn Mode, and test the system by

entering a valid code, followed by

activate.

3. How to use this Guide

The procedures in this Guide require the user to perform certain

sequential actions on the SMARTGUARDair keypad. To assist you, the

combined state of the three LED indicators on the keypad correspond

with particular steps within a procedure. When carrying out the

procedures, please be aware of the following:

The factory default Master Code (

Guide as an example only. Refer to Section 7 for instructions on how to

change the Master Code.

Indicates a particular key to be pressed on the keypad by the user

Indicates a lit LED

[ ] Indicates optional entries.

Important when choosing an access code number

If you intend using the Duress Security Parameter ensure

that no consecutive numbers are assigned as codes.

Ensure that the desired code has not already been allocated

4. Icons used in this guide

This icon indicates tips and other information that could be

useful during the installation.

This icon denotes variations and other aspects that should be

considered during installation.

This icon indicates a warning, caution or attention!

Please take special note of critical aspects that MUST

be adhered to in order to prevent injury.

Code

Master Code

4 5

into address

. The SMARTGUARDair will

. The receiver should now

1 2

3 4

Indicator LEDs

2 5

Indicator LEDs

is used throughout this