Centurion RDO-10A 설치 지침 및 사용자 설명서 - 페이지 3

{카테고리_이름} Centurion RDO-10A에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Centurion RDO-10A 13 페이지. Roller door opener

페이지 인쇄

FAILURE TO COMPLY WITH THE FOLLOWING SAFETY RECOMMENDATIONS MAY RESULT IN SERIOUS

 The installation of the Automatic Garage Door Opener

(Opener) must be carried out by a technically qualified or

licensed person. Attempting to install the Opener without

suitable technical qualification may result in severe personal

injury, death and/or property damage.

 Only install the Opener on a well functioning, properly

balanced and aligned garage door. An improperly balanced

or malfunctioning garage door could cause serious injury.

Have a qualified person check and if required, make repairs

to the door before installing the Opener. As a general rule a

garage door is deemed to be well balanced and aligned if it;

A. requires an equivalent amount of applied force to

manually open or close and, B. requires no more than 150N

(15kg) of applied force to either manually open or close and,

C. does not rise or fall more than 100mm when stopped at

any position between fully open or fully closed positions

and, D. does not rub on or make contact with any

supporting or surrounding structures.

 Repairs to garage doors must only be carried out by

technically qualified persons. Attempting to repair the

garage door without suitable technical qualification may

result in severe personal injury, death and/or property

damage.

 Remove or render inoperative all existing locks and ropes

prior to installation of the Opener.

 Do not connect the Opener to the power source until this

manual instructs you to do so.

 The Opener must be connected to a properly earthed

general purpose 220 ‐ 240VAC power outlet.

 Locate the wall control panel/push button; A. within site of

the garage door and, B. at a minimum height of 1.5 meters

above the ground so that it remains out of the reach of

small children and, C. away from all moving parts of the

door.

 Affix the entrapment warning label in a prominent position

adjacent to the garage door.

 After installing and adjusting the Opener the door must stop

and reverse direction when it comes into contact with a

40mm high solid object placed under it on the floor.

Safety Recommendations............

Installation Instructions...............

Settings and Adjustments...........

Engaging/Disengaging.................

Transmitter Learning....................

Door Height..................................

Door Travel Adjustment...............

Safety Reverse...............................

Auto Close......................................

Courtesy Light...............................

Dip Switches..................................

IMPORTANT SAFETY RECOMMENDATIONS

PERSONAL INJURY, DEATH AND/OR PROPERTY DAMAGE

Page

Section

4......

1 ‐ 8

5......

9 ‐ 22

5......

6......

7......

 The correct function of the safety reversing system should

be checked on a monthly basis.

 Make sure that the door reverses easily when it makes

contact with an obstruction.

 Never use the Opener unless the door is in full view and

free from objects such as cars, children and/or adults.

 Never allow children to use the Opener.

 Never use the Opener when children/persons are under or

near the path of the door.

 Children must be supervised at all times when near the door

and when the Opener is in use.

 Never attempt to disengage the Opener when there are

children/persons or and other objects including motor

vehicles under or near the path of the door.

 Removal of the screw‐on protective covers must only be

performed by a technically qualified person.

 Attempting to remove the protective covers or repair the

Opener without suitable technical qualification may result in

personal injury, death and/or property/product damage.

 Never attempt to make any repairs or remove any screw‐on

covers from the Opener without first disconnecting the

power supply cord from main power supply.

 Always ensure that the garage door is fully open before

driving into or out of the garage.

 Always ensure the door is fully closed before leaving the

driveway.

 Keep hands and loose clothing clear of the door at all times.

 For the safety reverse system to function it must first exert

force on an object/person/obstruction. As a result the

object/person/door may suffer damage or injury.

 Adjustments to the safety reverse force settings must be

carried out in strict accordance with the procedure set out

in this manual. Failure to do so may result in severe

personal injury, death and/or property damage.

 The safety reverse system is designed to work on

STATIONARY objects only. If the door encounters a moving

object during an Open or Close Cycle, serious personal

injury, death and/or property/product damage may occur.

Door Service Monitor........

LED Indicator........................

Safety Beams.......................

Speed Control......................

Terminal Connections.........

Vacation Mode....................

Installation Diagrams..........

Connection Diagram...........

Exploded View Diagram.....

Transmitter Details..............

‐ 3 ‐

Page

Section

8......