AFRISO VA-ALERT W 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} AFRISO VA-ALERT W에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AFRISO VA-ALERT W 8 페이지. Full tank alarm for sewage tanks

페이지 인쇄

VA-ALERT W

Full Tank Alarm for sewage tanks • Installation instructions

Functional testing:

Control Device

• The alarm consists of a transmitter unit

VA Alert W / T with a conductive sensor

for placement in the sewage tank / cis-

tern. This unit is powered by 2 AA bat-

teries.

• Receiver VA Alert W / R for placement

on the wall indoors in a dry location.

The unit is powered by an included

power supply unit (12VDC).

Pairing of transmitter and receiver

(is already done upon delivery):

For use, the transmitter and receiver are

paired with each other. This is done upon

delivery. If the transmitter or receiver is

changed, the pairing must be redone.

Open the transmitter part by pulling in one

cover. The lid is sealed with O-ring (see

picture above). Remove the circuit board

and insert 2 AA batteries in the battery

holder.

Subject to design modifications.

AFRISO EMA AB • Kilvägen 2, 232 37 Arlöv, Sweden • Tel +46-40-92 20 50 • [email protected] • www.afriso.se

Open here.

Connect the AC adapter to the receiving

device. The unit should be flashing green

and red and a beep is emitted. Thereaf-

ter the unit flashes quickly about every 3

seconds.

To pair the devices

Hold button 1 down until the red flash and

green flash simultaneously every other

time. Now it is possible to pair the sender

and receiver. Keep pressing button 1 down

and press also down button 2 on the

receiver until green LED remains lit. Con-

tinue to hold down both buttons until the

green light LED disappears and the buzzer

sounds for approximately one second.

Release the buttons, the pairing is

complete.

Press here.

Button 1.

Button 2.