AFRISO VA-ALERT W Instrukcja instalacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System bezpieczeństwa AFRISO VA-ALERT W. AFRISO VA-ALERT W 8 stron. Full tank alarm for sewage tanks
Drukuj stronęVA-ALERT W
Full Tank Alarm for sewage tanks • Installation instructions
Functional testing:
Control Device
• The alarm consists of a transmitter unit
VA Alert W / T with a conductive sensor
for placement in the sewage tank / cis-
tern. This unit is powered by 2 AA bat-
teries.
• Receiver VA Alert W / R for placement
on the wall indoors in a dry location.
The unit is powered by an included
power supply unit (12VDC).
Pairing of transmitter and receiver
(is already done upon delivery):
For use, the transmitter and receiver are
paired with each other. This is done upon
delivery. If the transmitter or receiver is
changed, the pairing must be redone.
Open the transmitter part by pulling in one
cover. The lid is sealed with O-ring (see
picture above). Remove the circuit board
and insert 2 AA batteries in the battery
holder.
Subject to design modifications.
AFRISO EMA AB • Kilvägen 2, 232 37 Arlöv, Sweden • Tel +46-40-92 20 50 • [email protected] • www.afriso.se
Open here.
Connect the AC adapter to the receiving
device. The unit should be flashing green
and red and a beep is emitted. Thereaf-
ter the unit flashes quickly about every 3
seconds.
To pair the devices
Hold button 1 down until the red flash and
green flash simultaneously every other
time. Now it is possible to pair the sender
and receiver. Keep pressing button 1 down
and press also down button 2 on the
receiver until green LED remains lit. Con-
tinue to hold down both buttons until the
green light LED disappears and the buzzer
sounds for approximately one second.
Release the buttons, the pairing is
complete.
Press here.
Button 1.
Button 2.
5