jali Dresser-Multi 조립 지침 매뉴얼 - 페이지 5

{카테고리_이름} jali Dresser-Multi에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. jali Dresser-Multi 11 페이지.

6. Place White Cams in the Box Base, Box Top and Valance cam holes. Depending on your design,

the Valance strip could be taller than this example. Screw Cam Bolts into the 5mm holes along the

Box Base front edge. Leave the 6mm Box Top holes for now.

Cam Bolt

Valance

White Cam

BOX ASSEMBLY

The following instructions will cover the assembly process for a single box. Repeat this process for

each box in your design. Refer to the Parts Diagram to confirm the configuration of each box. Note

that the following example doesn't contain Dividers.

Note about Dividers

If the box has more than one Divider, start by placing all the necessary shelves between the

Dividers. Wherever (if) the Divider features a central Cam Bolt, place one of the Shelves

with cams. After locating the other normal Shelves, lock these Shelf cams

into place to hold the structure together.

If the box has just one Divider, the Box Top and Box Base can now be

attached either end of the Divider, before fixing with 45mm CSK Screws.

Short tenons

for Outer Sides

Box Top

Dowel holes to

the floor, engraved

label facing towards

Assembly Instructions: Multi Section Dresser

White Cam

Box Base

Front Edge

7. With the front edges toward the floor, fit the Box Top to the RH

Side and secure with 45mm CSK Screws. Then proceed to add all

the Shelves. Wherever (if) the Box Sides feature central

RH Side

Cams to the floor

Box Top

Front Edge

Cam Bolts, place one of the Shelves with cams,

with the cam facing towards the Box Base.

Long tenon

Pilot drill, then fix with

45mm CSK Screws

Page 5 of 11