Centurion SECTOR II 설치 매뉴얼 - 페이지 11

{카테고리_이름} Centurion SECTOR II에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Centurion SECTOR II 19 페이지. Rectangular boom pole jack-knife led

SECTION 3

9. Route the LED harness through

the 12mm hole, making sure that

the cable can reach the end of

the pole.

10. Stick the LED strip to the Jack-

knife boom pole by removing the

blue backing. Start from the side

nearest to the 12mm hole.

Only the backing should be

peeled off the LED strip.

Do not attach the LED strip

to the underside of the

boom pole, i.e. the surface

facing the ground, as doing

so will result in damage to

the LED's in the instance

where the pole collides with

a vehicle due to tailgating.

It is recommended that the

strip is attached to the side

of the boom pole that is

facing oncoming traffic.

If the LED strip needs to be

shortened, it can be cut at

the terminals indicated in

figure 14.

LED strip

LED terminals

LED

strip

page 11

PHYSICAL INSTALLATION

LED

harness

FIGURE 12

FIGURE 13

LED terminals

FIGURE 14