Centurion SECTOR II 설치 매뉴얼 - 페이지 9
{카테고리_이름} Centurion SECTOR II에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Centurion SECTOR II 19 페이지. Rectangular boom pole jack-knife led
페이지 인쇄SECTION 3
3.2. Boom pole modifications
1. Remove the silicone plug
and plastic bumper from the
rectangular boom pole.
2. Mark and centre punch a hole
position 30mm away from the
end of the Coupling.
Ensure that the hole is
facing the direction of
traffic.
3. Drill one 12mm hole.
The hole must be drilled
through only one wall of
the boom pole.
4. Route the LED harness through
the 12mm hole, making sure that
the cable can reach the end of
the pole.
LED harness
page 9
PHYSICAL INSTALLATION
FIGURE 6
12mm
hole
FIGURE 7
FIGURE 8
www.centsys.com