Centurion Scientific PrO-Eazy 설치 지침 매뉴얼 - 페이지 16

{카테고리_이름} Centurion Scientific PrO-Eazy에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Centurion Scientific PrO-Eazy 20 페이지.

Fault codes

Prime and Dual models only. Ambient

Fault codes are shown in the Speed section of the LED display (shown on previous page

The following List show what each Code means and what to do.

F A 5 0

F A 2 1

Non Fault Codes

Speed will not go beyond 2000 Rpm.

The Electronics have set the Speed to safe mode

Check the rotor bottom has magnets fitted

Check correct rotor is in use against program chosen

If not then

Noisy

Unbalanced tubes, see Rotor pages

Lid seal needs replacing

Rotor Lid not fitted

Lid support fail

Spring has failed.

Inverter Drive

Inverter error

Contact our Service Department

Look at the Obround viewing port (Rear)

Note the Code shown in the inverter display.

Turn off the power at the wall mains switch only.

WAIT 3 minutes, Turn on again and Run. If problem persists

Contact our Service Department.

As above.

Obround viewing port

shown.