Airflow OW7205 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Airflow OW7205에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airflow OW7205 8 페이지. Smart series wall/window fans

• Where double glazed windows are required the Double-Glazing Kit OW7957 for

the 23/9 series or the OW7999 for the 30/12 series can be used. They suit

applications with up to 300mm intervals between the windows.

INSTALLATION INSTRUCTIONS

All fans should be installed by a suitably qualified person in accordance with AS/

NZ3000.2000 and relevant building codes. Disconnect supply before making any

electrical connections.

For best results the fan should be mounted as high as possible, and provision

should be made for return air to enter the room on the opposite side.

Cut appropriate size hole through window or wall as per template on this

instruction and keep in mind a minimum clearance from obstructions (such as

window sills) will be needed (230mm from centre of fan for 23/9 series and 245mm

for 30/12 series).

Outside the Room

1. Separate fan into four main components, see Fig.1.

2. Place external grille through hole (ensure grille vents are facing downwards

and window gasket is in place).

Inside the Room

1. Run supply cable to the top where fan is to be positioned (ensure end of cable

is stripped and terminal block is removed to allow cable access), see Fig.2.

2. Place gasket over external grille's spigot.

3. Push Grey Enclosure (with terminal block to the top) on to spigot. The ratchet

operation will hold the Enclosure to the External Grille. Push Enclosure until it

is firmly up against the gasket. Snug fit is achieved by tightening of fixing tabs

with a screwdriver, see Fig.2a.

4. Make electrical connections to the terminal block and ensure cable is

adequately retained.

5. Push Fan Assembly through Enclosure until it clicks in place by means of two

locking tabs on left and right of Enclosure. Secure fan assembly by tightening

fixing screw, see Fig.3.

6. Attach Internal Grille to Enclosure and secure in place by tightening Grille

fixing screws, see Fig.3.

7. Make electrical connections back at controller or appropriate isolator.

Inside the Room

1. Separate fan into four main components, see Fig.1.

2. Remove the four rectangular copper tags (located at each corner of the Grey

Enclosure), see Fig. 2a.