2KRC P002 조립 설명서 - 페이지 6

{카테고리_이름} 2KRC P002에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 2KRC P002 17 페이지. Hyper ep. fun scale racer

Cut Elev. Control hone as show.

install the " Z" push rod with control horn first then

check the control wire was operation smooth or not

when you install the wire and pre install Elevator

Control horn.

Before you ensure the control wire are operation

smooth, please do not glue the control horn in anyway.

If you find the "Z" end control wire angle not right,

please adjust it again or turn to other side to install the

"Z" end with the control horn.

After you ensure the Elevator Control wire was good

fit with Elevator Control horn and other end of control

wire was already fit in side the adjuster that already

install on the Elevator Servo,(see PIC. 16) you can

glue the control horn with thin CA. as show.