Green Frog Designs Duck & Goose House Large 사용 및 관리 방법 - 페이지 5

{카테고리_이름} Green Frog Designs Duck & Goose House Large에 대한 사용 및 관리 방법을 온라인으로 검색하거나 PDF를 다운로드하세요. Green Frog Designs Duck & Goose House Large 6 페이지.

Fit one Vent Cover to the gridded side of the Left Side

Wall using a 30mm screw, a standard washer, a 25mm

washer and nylock nut (as shown in the diagram above).

Tighten the nut until the vent can rotate using gentle

pressure. It should not spin freely.

Fit the other vent cover to the Side Wall in the same

way. The fourth vent does not have a cover, to ensure

the birds have some fresh air at all times.

Fit the Front Wall (patterned face outermost) to the end

with the double-hole lugs using Pi-Clips.

Fit the Roof Clips to the Front Wall and Upper Back Wall

using Pi-Clips.

Printed on recycled paper

HOW TO ASSEMBLE

Fit both Side Walls to the Base using Pi-Clips. Ensure

that the Base double-hole lugs are at the front, and the

patterned side is uppermost.

Fit the Roof Support and Base Support between the two

side walls.

Fit the Upper Back Wall using Pi-Clips and then the Back

Door using Linch Pins.

Fit the Door Bar to the inside top of the Front Wall with

Pi-Clips.

Page 5 of 6