Gandy 24H12 운영자 매뉴얼 - 페이지 8

{카테고리_이름} Gandy 24H12에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gandy 24H12 10 페이지. 24” & 36” spreaders
Gandy 24H12에 대해서도 마찬가지입니다: 운영자 매뉴얼 (8 페이지), 운영자 매뉴얼 (8 페이지)

페이지 인쇄

4. With the nuts and washers removed you will see the angled slots on the rear hanger.

With a small hammer gently tap on the end of the rear hanger as shown to loosen it from the studs.

See Diagram D.

With the hanger loose, slide it in the direction shown until the threaded studs align with the straight up and

down area of the slot. See Diagram E.

Pivot the rear hanger away from the bottom and all the way off the studs.

This will allow the hanger to un-hook from the slide and be removed. See Diagram F.

Lift up and pivot the slide away from the bottom.

This will allow the side to unhook from the front hanger. See Diagram G.

Note: Be careful when handling the bottom & slide so you do not drop, bend, or dent it.

Diagram D

Diagram E

Diagram G

*For compete assembly instructions see the Parts & Assemble Manual that was supplied with the spreader.

Diagram F

~6 ~

OPP-36-24-A1