Gantner 631325 매뉴얼 - 페이지 4
{카테고리_이름} Gantner 631325에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gantner 631325 7 페이지. Battery powered mifare and iso 15693 lock
페이지 인쇄
Mounting on Metallic Doors
6
9
5
2
17 mm (0.67´´)
6
min. 18 mm (0.71´´)
max. 26 mm (1.02´´)
1. GAT ECO.Side Lock 7000
2. GAT NET.Lock Bolt Set 7200
3. Mounting screws for GAT ECO.Side Lock 7000
5. Door contact
6. Mounting screws for bolt set
Cut-outs in the locker door
Cut-outs must be made in the inside and outside walls of the locker
door to mount the GAT NET.Lock Bolt Set 7200 and label carrier. The
installation procedure is described on the next page. The measurements
for the cut-outs are shown in the diagram below.
8
9
Valid from June 10th, 2015 • Technical data subject to modification without notice!
4
DB_GAT-ECOSide-Lock7000--EN_11.indd • Part No. 642832
Inside of locker
1
3
3
3
74 mm (2.91´´)
Inside of locker
Locker door
(Front view without label carrier)
1
6
3
2
3
7
3
6
15.1 mm (0.59´´)
7. LED position
8. Cut-out for GAT NET.Lock BoltSet 7200
9. Cut-out for label carrier
10. Label carrier
Locker door (outer wall)
Cut-out area marked in grey
9
LED
16.8 mm (0.66´´)
67.6 mm (2.66´´)
Locker door
(Front view with label carrier)
10
7
Locker door (inner wall)
Cut-out area marked in grey
4 x holes for screws,
Ø 3.6 mm (0.14´´)
8
6
LED position
6
29 mm
16.8 mm
(1.14´´)
(0.66´´)
62.6 mm (2.46´´)
www.gantner.com
(F
1
7
19.3 mm
(0.76´´)