Gantner 631325 매뉴얼 - 페이지 7

{카테고리_이름} Gantner 631325에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gantner 631325 7 페이지. Battery powered mifare and iso 15693 lock

페이지 인쇄

Set-up and configuration

Power supply

The unit is powered by two 3.6 V AA Lithium SAFT - LS14500 batteries

(see technical data). In order to access the battery compartment of the

GAT ECO.Side Lock 7000, the red battery cover (1 in diagram below) on

the underside of the housing must be removed.

Inserting the battery:

1. Ensure battery polarity is the same as shown in the diagram above.

2. Press the battery down into the compartment until it locks into place.

3. Reinstall the battery cover over the battery compartment and push down

until the battery cover is level with the surrounding GAT ECO.Side Lock

7000 housing.

Insert the batteries directly before the GAT ECO.Side Lock 7000 is

mounted to avoid unnecessary battery usage.

Only use the approved battery listed in the "Accessories" section

on page 1 (2 x Batterie 3,6V Lithium SAFT - LS14500, Part No.

912012).

www.gantner.com

Configuration

The configuration settings of the GAT ECO.Side Lock 7000 can be adjusted

using a PC/laptop and GAT Config Manager configuration software.

A Micro-B USB port is provided on the side of the GAT ECO.Side Lock

7000 for computer connectivity.

1. Connect the USB cable to the GAT ECO.Side Lock 7000 (1).

2. Connect the other end of the USB cable to the USB port of a PC/

3. Hold the service data carrier next to the reading field to activate

The USB cable, service data carrier and configuration software are

included in the GAT ECO.Side Lock Basic Set F/ISO (Part No. 812528).

A detailed description of the configuration settings and how to configure

the GAT ECO.Side Lock 7000 can be found in the manual.

Valid from June 10th, 2015 • Technical data subject to modification without notice!

laptop

configuration mode (2).

The WEEE symbol on GANTNER products and their packaging

indicates that the corresponding material must not be disposed

of with normal household waste. Instead such marked waste

equipment must be disposed of by handing it over to a designated

electronic waste recycling facility. Separating and recycling this

waste equipment at the time of disposal will help to conserve

natural resources and ensure that it is recycled in a manner that

protects human health and the environment. Please contact your

local authority for further details of your nearest electronic waste

recycling facility.

Safety instructions

- This device must be installed by qualified personnel only.

- The applicable safety and accident prevention regulations

must be observed.

- Safety devices must not be removed.

- Please observe the technical data of the device specified

on the data sheet.

DB_GAT-ECOSide-Lock7000--EN_11.indd • Part No. 642832

SERVICE