Gantner 631325 Руководство - Страница 7
Просмотреть онлайн или скачать pdf Руководство для Замки Gantner 631325. Gantner 631325 7 страниц. Battery powered mifare and iso 15693 lock
Печатать страницу
Set-up and configuration
Power supply
The unit is powered by two 3.6 V AA Lithium SAFT - LS14500 batteries
(see technical data). In order to access the battery compartment of the
GAT ECO.Side Lock 7000, the red battery cover (1 in diagram below) on
the underside of the housing must be removed.
Inserting the battery:
1. Ensure battery polarity is the same as shown in the diagram above.
2. Press the battery down into the compartment until it locks into place.
3. Reinstall the battery cover over the battery compartment and push down
until the battery cover is level with the surrounding GAT ECO.Side Lock
7000 housing.
Insert the batteries directly before the GAT ECO.Side Lock 7000 is
mounted to avoid unnecessary battery usage.
Only use the approved battery listed in the "Accessories" section
on page 1 (2 x Batterie 3,6V Lithium SAFT - LS14500, Part No.
912012).
www.gantner.com
Configuration
The configuration settings of the GAT ECO.Side Lock 7000 can be adjusted
using a PC/laptop and GAT Config Manager configuration software.
A Micro-B USB port is provided on the side of the GAT ECO.Side Lock
7000 for computer connectivity.
1. Connect the USB cable to the GAT ECO.Side Lock 7000 (1).
2. Connect the other end of the USB cable to the USB port of a PC/
1
3. Hold the service data carrier next to the reading field to activate
The USB cable, service data carrier and configuration software are
included in the GAT ECO.Side Lock Basic Set F/ISO (Part No. 812528).
A detailed description of the configuration settings and how to configure
the GAT ECO.Side Lock 7000 can be found in the manual.
Valid from June 10th, 2015 • Technical data subject to modification without notice!
laptop
configuration mode (2).
1
The WEEE symbol on GANTNER products and their packaging
indicates that the corresponding material must not be disposed
of with normal household waste. Instead such marked waste
equipment must be disposed of by handing it over to a designated
electronic waste recycling facility. Separating and recycling this
waste equipment at the time of disposal will help to conserve
natural resources and ensure that it is recycled in a manner that
protects human health and the environment. Please contact your
local authority for further details of your nearest electronic waste
recycling facility.
Safety instructions
- This device must be installed by qualified personnel only.
- The applicable safety and accident prevention regulations
must be observed.
- Safety devices must not be removed.
- Please observe the technical data of the device specified
on the data sheet.
DB_GAT-ECOSide-Lock7000--EN_11.indd • Part No. 642832
SERVICE
2
7