Gantner 631325 Руководство - Страница 6

Просмотреть онлайн или скачать pdf Руководство для Замки Gantner 631325. Gantner 631325 7 страниц. Battery powered mifare and iso 15693 lock

Печатать страницу

Mounting on Glass Doors

11 mm

17 mm

(0.43´´)

(0.67´´)

Installation requirements for GAT ECO.Side Lock 7000 and bolt set

Please pay particular attention to the following points:

- When the locker door is pressed shut, ensure there is no gap between

the bolt set (2) and the front of the GAT ECO.Side Lock 7000. Ideally

the bolt set should touch the front of the lock.

- The front side of the bolt set and the GAT ECO.Side Lock 7000 must be

aligned parallel to each other.

Valid from June 10th, 2015 • Technical data subject to modification without notice!

DB_GAT-ECOSide-Lock7000--EN_11.indd • Part No. 642832

74 mm (2.91´´)

14.6 mm (0.57´´)

17.6 mm (0.69´´)

Installation procedure

Note: Before installing all locks in a new locker system, a test installation

of at least one lock and a final function check must be performed.

Only once the functional testing is successfully completed may the

remaining locks be installed in the same way.

1. Drill 3 holes (3) for the GAT ECO.Side Lock 7000 into the locker wall.

2. Insert the batteries into the GAT ECO.Side Lock 7000 (see page 7).

3. Mount the GAT ECO.Side Lock 7000 with 3 screws (3) on the inside

locker wall.

Attention: Use the correct screws according to the type of locker

material, max. Ø 4 mm (0.16´´). The maximum allowed

tightening torque of the screws is 2 Nm (1.47 lb-ft).

4. Use adhesive to attach the GAT NET.Lock BoltSet 7300 in the correct

position to the inside of the locker door. Ensure the bolt set and metal

support are screwed together before applying adhesive. GANTNER

Electronic GmbH has successfully tested the following adhesives:

For transparent glass doors:

Conloc UV 680 from EGO. Only suitable for transparent glass doors

without color-coating as this adhesive requires exposure to UV light

(i.e., daylight) to cure.

For non-transparent glass doors:

Conloc UV 683 and Conloc Aktivator 953 from EGO. This combination

does not require UV light to cure and is also suitable for opaque glass

doors (e.g., with painted or color-coated tint treatment).

Attention: If comparable adhesives are to be used, test to ensure the

adhesive meets the strength requirements. Always follow

the adhesive manufacturer's instructions.

5. A label (GANTNER standard design or custom design) can be

attached to the locker front. If a custom label design is used, ensure

that a transparent field for the LED light is included in the label design.

6. Test the locker door to confirm that it can close easily and the door

shackle inserts correctly into the GAT ECO.Side Lock 7000.

1. GAT ECO.Side Lock 7000

2. GAT NET.Lock Bolt Set 7300

3. 3 x mounting screws for the

GAT ECO.Side Lock 7000

5. Door contact

7. LED position

12. Metal support for glass door (included

in the GAT NET.Lock BoltSet 7300)