IKEA FRAMTID 사용자 설명서 - 페이지 15

{카테고리_이름} IKEA FRAMTID에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA FRAMTID 24 페이지. Hobs
IKEA FRAMTID에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 설치 매뉴얼 (12 페이지), 사용자 설명서 (48 페이지)

페이지 인쇄

1. Control Panel

ENGLISH

What to do if ...

Problem

The appliance does not work.

A message is displayed such

as: F2, F3C, F7 or Err2, Err3,

Err5.

The food is unevenly heated.

Food isn't turning.

Authorized Service Centre

Before calling the Authorized Service Centre:

1. See if you can solve the problem on your own (see the "What to do if ..." table).

2. Switch the appliance off and on again to see if the problem has disappeared.

If the fault persists after the above checks, contact IKEA Authorized Service Centre.

Always specify:

the type of fault;

exact type and model of appliance;

the Authorized Service Centre number (the number given after

the word "Service" on the rating plate) located on the inside

edge of the oven cavity (visible when the door is open);

your full address;

your telephone number.

If any repairs are required, please contact IKEA Authorized Service Centre (to guarantee

that original spare parts will be used and repairs carried out correctly).

Possible cause

The mains power supply

or the appliance is not

connected.

The door isn't closed.

The oven has

recognized that a fault

has occured in one of it's

sensors or similar.

Very thin parts such as

chicken wingtips and

such are not shielded.

The food was heated at

a power level too high.

The turntable has

stopped.

The turntable has

stopped.

Solution

Check your fuses and ensure

that there is power avaliable.

Open and then close the door

before you try again.

Disconnect and wait 10

minutes before reconnecting,

then try to operate the oven

once more. If the problem

persists: call service.

Shield the thinner parts with

aluminum foil.

Choose a lower power level.

Check that the turntable and

turntable support is in place

and the food is well centered,

not touching the cavity walls.

Check that the turntable and

turntable support is in place

and the cavity bottom is

clean.