Gantner Q.brixx 빠른 시작 매뉴얼
{카테고리_이름} Gantner Q.brixx에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gantner Q.brixx 3 페이지.
페이지 인쇄
Q
.uick Start Guide: Q.brixx Assembly and Configuration Guide
Purpose: This guide will describe how to put together a Q.brixx system using a test controller (i.e.
Q.station or Q.gate) and the measurement modules. To disassemble or replace a module, simply reverse
the procedure.
Tools Required:
-
Torx T10 screw driver
-
2.5 mm hex key
Items Required:
-
Gantner test controller: Q.station or Q.gate.
-
Gantner measurement module: at least one measurement module.
Procedure:
1. Each controller and measurement module includes a base. Separate the base from the module
by removing the 2 x Torx T10 screws from the back of the base.
2. A controller in the brixx packaging comes with 2 x handles (a left side and a right side). Attach
the left side handle to controller's base.
3. Attach all the bases together moving from left to right. Secure the bases together using a 2.5
mm hex key (2 x screws):
Gantner Instruments Incorporated
9835 Carroll Centre Road, Suite 100
San Diego, CA 92126 USA
www.gantnerinstruments.com
Toll Free: (877) 725-6997 (877 QBLOXXS)
Direct:
(858) 537-2060
Toll Free Fax: (800) 303-9381
Direct Fax:
(858) 537-2064