Green Lighting TRI-SENSOR GL4612LU 조립 및 피팅 지침 - 페이지 3

{카테고리_이름} Green Lighting TRI-SENSOR GL4612LU에 대한 조립 및 피팅 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Green Lighting TRI-SENSOR GL4612LU 6 페이지.

INSTALLATION

Ensure electricity is switched off at the mains before installing or maintaining this lantern.

THIS FITTING MUST BE INSTALLED IN ACCORDANCE WITH

CURRENT IEE WIRING REGULATIONS AND BUILDING

REGULATIONS (PART P). FOR YOUR OWN SAFETY, THIS

LANTERN MUST BE EARTHED. UNDER NO CIRCUMSTANCES SHOULD

THIS METAL FITTING BE WIRED TO AN UNEARTHED

CIRCUIT. CONTACT A QUALIFIED ELECTRICIAN TO

INSTALL A SUITABLE EARTH FACILITY.

IF YOU ARE IN ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.

Please note: For new installations, check for any electrical cables or pipe work

(gas/water) in the vicinity of the intended mounting point for the product, before

proceeding with the installation.

1. Remove the junction box by removing the dome nuts,

sealing washers and metal washers. Take care of the

weather proof gasket (FIGURE 1).

FIGURE 1

3 X2

2 X3

1 X2

4 X3