HIKVISION H1T Series 사용자 설명서 - 페이지 8
{카테고리_이름} HIKVISION H1T Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION H1T Series 14 페이지. Turbo hd dome camera
HIKVISION H1T Series에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지), 사용자 설명서 (17 페이지), 사용자 설명서 (17 페이지), 사용자 설명서 (14 페이지), 사용자 설명서 (14 페이지)
페이지 인쇄
Figure 2-10 Disassemble the Camera
2. Pry the mounting base to remove the mounting
base from the camera body.
3. Paste the drill template (supplied) to the place
where you want to install the camera.
4. Drill the screw holes according to the drill template,
and the cable hole (optional) on the ceiling.
Note:
Drill the cable hole, when adopting the ceiling outlet to
route the cable.
5. Secure the mounting base to the ceiling with the
supplied screws.
Figure 2-12 Fix the Mounting Base to the Ceiling
Note:
In the supplied screw package, both self-tapping
screws and expansion bolts are contained.
For cement ceiling, expansion bolts are required to
fix the camera. For wooden ceiling, self-tapping
screws are required.
6. Route the cables through the cable hole, or the side
opening.
7. Secure the camera on the mounting base.
8. Connect the corresponding cables, such as power
cord, and video cable.
9. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
1). Hold the camera body and rotate the enclosure
to adjust the pan position [0° to 360°].
2). Move the camera body up and down to adjust
the tilt position [0° to 75°].
Figure 2-11 Drill Template
Figure 2-13 Secure the Camera
Clip Plate
Notch
Expansion Bolts
Fixing Screw