Airflow 90000518 설치 및 운영 매뉴얼 - 페이지 3

{카테고리_이름} Airflow 90000518에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airflow 90000518 6 페이지.

Front Cover Removal

Before installation can commence you need to remove the front cover by unscrewing the two

screws at the bottom of the cover (see Fig. 1). When the hand dryer is fixed to the wall, the cover

should be replaced, and the two screws tightened accordingly.

Mounting on the Wall

Fix the hand dryer to the wall with the fixing kit provided using the enclosed template to mark out

where the holes should be drilled. It is recommended that you use the raw plugs and screws

provided in the fixing kit. The hand dryer should always be positioned with the air outlet facing

downwards.

Wiring

For hard wiring into a wall in a washroom:

Operation

The hand dryer automatically starts up when it senses the hands approaching the air outlet

mechanism and stops when the hands move away. The unit has no heating element - air is heated

by the power of the motor which allows considerable energy savings compared to traditional hand

dryers. The first daily use of the product will therefore blow out seemingly cold air but from the

second drying cycle, the air temperature will warm up.

The device has a system that prevents vandalism – for instance if the sensors are covered to try

and force continuous operation, the hand dryer will only work for 35 seconds and then

automatically stop and go into standby. To resume normal functionality, the cover blocking the

sensors will have to be removed and normal functionality will resume in 3-4 seconds.

Fig. 1

Page 3 of 6

80000413 Issue 2 – 07/23

ecodry 1100