Airflow 90000518 설치 및 운영 매뉴얼 - 페이지 5
{카테고리_이름} Airflow 90000518에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airflow 90000518 6 페이지.
페이지 인쇄WARNING: In the rare case of a thermal overload (over heating of the motor), a thermostat
with automatic reset protection will suspend the operation of the motor. The thermostat will
automatically reset the motor after 10 – 15 minutes when the specific motor temperature
drops below 100°C.
IMPORTANT:
•
Do not use this product for a function different to which it is intended.
•
Do not expose the appliance to the elements such as rain, sun etc.
•
Do not make any changes to the device.
•
Do not obstruct the air outlet point or air inlet grille.
•
Do not insert any object into the air outlet or air inlet grille.
•
In case of failure/ malfunction, disconnect from the power supply and contact your
installer.
Troubleshooting
1. If the dryer continuously blows cold air - the dryer will warm up after use as the heat is
generated from the operation of the motor. This is normal operation.
2. The dryer runs continuously – decrease the sensitivity of the activation sensor by turning
the white potentiometer on the board located inside the main body of the dryer (see Fig. 3)
anti clockwise with a pot adjuster/ small screwdriver. Adjust to suit the level of sensitivity
required.
3. The dryer does not operate – check all connections, if this fails, please contact your
installer.
Please contact Airflow Developments Ltd at
for further assistance.
Fig. 3
Page 5 of 6
or Tel +44 (0)1494 525 252
80000413 Issue 2 – 07/23