Airflow 90000518 Installatie- en bedieningshandleiding - Pagina 5

Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} Airflow 90000518. Airflow 90000518 6 pagina's.

WARNING: In the rare case of a thermal overload (over heating of the motor), a thermostat

with automatic reset protection will suspend the operation of the motor. The thermostat will

automatically reset the motor after 10 – 15 minutes when the specific motor temperature

drops below 100°C.

IMPORTANT:

•

Do not use this product for a function different to which it is intended.

•

Do not expose the appliance to the elements such as rain, sun etc.

•

Do not make any changes to the device.

•

Do not obstruct the air outlet point or air inlet grille.

•

Do not insert any object into the air outlet or air inlet grille.

•

In case of failure/ malfunction, disconnect from the power supply and contact your

installer.

Troubleshooting

1. If the dryer continuously blows cold air - the dryer will warm up after use as the heat is

generated from the operation of the motor. This is normal operation.

2. The dryer runs continuously – decrease the sensitivity of the activation sensor by turning

the white potentiometer on the board located inside the main body of the dryer (see Fig. 3)

anti clockwise with a pot adjuster/ small screwdriver. Adjust to suit the level of sensitivity

required.

3. The dryer does not operate – check all connections, if this fails, please contact your

installer.

Please contact Airflow Developments Ltd at

for further assistance.

Fig. 3

Page 5 of 6

or Tel +44 (0)1494 525 252

80000413 Issue 2 – 07/23