IKEA EVENTUELL 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 10

{카테고리_이름} IKEA EVENTUELL에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA EVENTUELL 48 페이지. 30" (76.2 cm) range hood liner

페이지 인쇄

2. Locate side mounting bracket flush to the bottom of the cabinet

side and against the inside of the front cabinet face. Orient the

bracket as shown in the following illustration. Drill ¹⁄₈" (3 mm)

pilot holes in 8 places, attach a bracket using four 4.5 x 13 mm

#2 Phillips screws to each side of the cabinet, and tighten.

Additional plastic washers in hardware package are supplied as

spacers for cabinet walls thinner than ½" (13 mm).

Bracket Orientation for 30" (76.2 cm) Cabinet

A. 30" (76.2 cm) cabinet

B. Screws - 4.5 x 13 mm #2 Phillips (8)

C. Metal washers (optional)

D. Mounting bracket (2) (position for 30" [76.2 cm] cabinet)

Cabinet Venting Preparation

1. Complete cabinet preparation following the instructions for

your type of venting. Determine venting cutout locations and

cut out vent openings in the cabinets, walls and/or soffit.

Venting Outside Through the Roof

Measure and mark the lines as shown. Use a saber saw or

keyhole saw to cut an opening through the top of the cabinet

and the roof for the vent.

Go to Step 2.

A. Cutout

B. 6¼" (15.9 cm)*

³⁄₄

C. 7

" (19.7 cm) centerline to cabinet front

D. Centerline

*NOTE: For 12" (30.5 cm) high cabinets a 6¼" deep x 8" wide

(15.9 cm x 20.3 cm) rectangular opening in the cabinet top is

required for damper transition clearance.

Venting Outside Through the Wall

Install the 6" (15.2 cm) vent transition to the top of the range

hood liner using two 3.5 x 9.5 mm T10 screws. Assemble the

vent duct that you will use over the 6" (15.2 cm) vent

transition. Measure from the bottom of the range hood liner to

the horizontal centerline of the vent opening (A).

A. Measurement A

B. Horizontal centerline of vent opening

C. 3.5 x 9.5 mm T10 screws

D. Range hood liner

Remove the vent duct from the range hood liner.

Transfer measurement A to the cabinet back wall. Measure

from the underside of the cabinet. Mark the cutout as shown.

Use a saber saw or keyhole saw to cut a round opening

through the back of the cabinet and the exterior wall for the

vent.

Go to Step 2.

A. Measurement A

B. Centerline

C. 6¼" (15.9 cm) round cutout