IKEA EVENTUELL 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 11

{카테고리_이름} IKEA EVENTUELL에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA EVENTUELL 48 페이지. 30" (76.2 cm) range hood liner

페이지 인쇄

Non-Vented (recirculating) Installation Through the

Soffit/Cabinet

Measure and mark the centerline location for the cutout in the

cabinet top. Use a saber saw or keyhole saw to cut an

opening for the vent.

A. Cutout

B. Vent cover (installation without soffit)

C. See the following chart.

³⁄₄

D. 7

" (19.7 cm) centerline to cabinet front

E. Centerline

Cabinet Height

Hole Shape and Size

12" (30.5 cm)

A 6¼" deep x 8" wide (15.9 cm x 20.3 cm)

rectangular opening in the cabinet top is

required for damper transition clearance.

15" (38.1 cm)

A 6¼" (15.9 cm) diameter round opening is

cabinet or soffit

required.

installation

18" (45.7 cm) or

A 5¾" (14.6 cm) diameter round opening is

24" (61.0 cm)

required.

Measure and mark the centerline of the cabinet to the soffit

above.

Measure from the bottom of the cabinet to the centerline of

the where the vent will come through the soffit. Mark the

location and use a saber saw or keyhole saw to cut a 5¾"

(14.6 cm) hole for the vent cover. Attach the vent cover using

two 4.5 x 13 mm #2 Phillips screws.

A. Vent cover

B. Centerline

For non-vented (recirculating) installations only, the range

hood can be vented indoors through the top of the cabinet.

For non-vented (recirculating) installations, charcoal filters are

necessary. See the "Range Hood Care" section for

instructions on installing charcoal filters.

The Charcoal Filter Kit Part Number W10272068 must be

used.

Complete Preparation

2. If it is not yet attached, install the 6" (15.2 cm) vent transition

to the top of the range hood liner using two 3.5 x 9.5 mm T10

screws.

A. Vent transition

B. 3.5 x 9.5 mm T10 screws

3. Install the vent system according to the method needed. Use

caulking to seal the exterior wall or roof opening.