CeoTronics CT-GateCom Base 사용 설명서 - 페이지 16

{카테고리_이름} CeoTronics CT-GateCom Base에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CeoTronics CT-GateCom Base 20 페이지. Transmitter/receiver headsets for wireless duplex communication

페이지 인쇄

12.2 Principle of subscription

For on-air subscription at a DECT device always the on/off switch and the subscription button(s)

are used.

Every time notice the special CeoTronics operating instructions for the other CT-DECT device.

NOTE

The on-air subscription is a procedure which has to be performed once only by the factory. It

must be performed again only in the case a DECT device that isn't subscribed to the system has

to be used within the system.

Principle of subscription

Each device is equipped with a DECT module and has its own identification number. First of all an

allocation must always take place between the base device (CT-GateCom Compact) and the maximum

of four standard devices. This subscription procedure, which has to be performed once only, is

performed on the base device and the maximum of four standard devices manually by means of a

procedure carried out by the operator.

If a fifth standard device would be subscribed to the base device, the standard device that was

subscribed in first would be deleted from the data memory of the base device. See the following

example.

Principle of subscription (example)

A standard device that is deleted from the data memory of the base device cannot communicate any

longer with the CT-DECT system. In this case the standard device has to be subscribed again to the

base device according to the subscription procedure.

Once the subscription procedure has been successfully concluded, the identity of the communication

participants is stored in the data memory of the device. The standard device stores one base device.

The base device stores the last four successful subscribed standard devices.

Time Out

If no successful subscription between a standard device and the base device was achieved after

maximally 2 minutes, a »Time Out« occurs. The »Time Out« is signalized by a tone sequence of 4 short

deep tones in the communication headset of the Standard device, which repeats itself every 4 seconds.

After a »Time Out« all necessary standard devices have to be subscribed again to the base device.