CeoTronics CT-GateCom Base 사용 설명서 - 페이지 17
{카테고리_이름} CeoTronics CT-GateCom Base에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CeoTronics CT-GateCom Base 20 페이지. Transmitter/receiver headsets for wireless duplex communication
페이지 인쇄Note
Two ore more standard devices can never be simultaneously subscribed to the base device,
they must always be subscribed one after the other. With two ore more standard devices it is
recommendable to subscribe all standard devices one after the other to the base device,
because a standard device can be deleted (see »Principle of subscription«).
A standard device can only be subscribed in one base device at the same time, never in two
or more base devices.
Comply with the instruction step sequence.
After subscription the devices have to be switched off again.
12.3 On-air subscription
12.3.1 On-air subscription of the first standard headset
a. On the base headset and on the first standard headset pull the ear cushion (Fig. 9/a) off the left-
hand headset muff. The subscription button (Fig. 9/b) resides in the shell ring of the headset muff.
b. On the base headset press the subscription button (Fig. 9/b) and switch on the base headset by
means of the On/Off switch and volume control (rotary knob Fig. 3/b). After switching on keep the
subscription button pressed for at least 2 seconds and then release the subscription button.
Immediately carry out step »c«, otherwise a »Time Out« may occur.
c. On the standard headset press the subscription button (Fig. 9/b) and switch on the standard headset
by means of the On/Off switch and volume control (rotary knob Fig. 3/b). After switching on keep the
subscription button pressed for at least 2 seconds and then release the subscription button.
The on-air subscription is started and in both headsets a short high beep tone is audible periodically
every 2 seconds. After approx. 30 seconds a high double-beep tone can be heard both in the base
headset and in the standard headset. The on-air subscription is successful completed.
Two low tones before the high double-beep tone signalize an incorrect subscription. In this case
switch off the headsets and restart the on-air subscription procedure again.
d. After the on-air subscription switch off the headsets.
12.3.2 On-air subscription of the other three standard headset
a. Ensure that the subscribed first headset and the base headset are switched off.
b. On the standard headset pull the ear cushion (Fig. 9/a) off the left-hand headset muff. The
subscription button (Fig. 9/b) resides in the shell ring of the headset muff.
c. Repeat the subscription procedure as described in section 12.3.1, »b« and »c«, for the base headset
and for the other three standard headsets.
d. After the on-air subscription switch off the headsets.
17