IKEA IH6302YS0 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 11

{카테고리_이름} IKEA IH6302YS0에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA IH6302YS0 44 페이지. 30"(76.2cm) wall-mount canopy range hood

페이지 인쇄

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors

and odors from the cooktop area. For best results, start the hood

before cooking and allow it to operate several minutes after the

cooking is complete to clear all smoke and odors from the

kitchen.

The hood controls are located on the front panel on the right side

of the range hood.

A. Greasefilter

B. Greasefilter handle

C. Blower and light controls

D. Incandescent lamp housings

©©©©

A. On/Off light button

B. Blower off and speed minimum button

C. Blower speed medium button

D. Blower speed maximum button

Operating the light

The On/Off light button controls both lights. Press once for On

and again for Off.

Operating the blower

The BLOWER SPEED buttons turn the blower on and control the

blower speed and sound level for quiet operation. The speed can

be changed anytime during fan operation by pressing the desired

blower speed button.

Press the BLOWER OFF button a second time to turn the blower

off.

RANGE HOOD CARE

IMPORTANT:

Clean the hood and grease filters frequently

according to the following instructions. Replace grease filters

before operating hood.

Exterior Surfaces:

To avoid damage to the exterior surface, do not use steel wool or

soap-filled scouring pads.

Always wipe dry to avoid water marks.

Cleaning Method:

•

Liquid detergent soap and water, or all-purpose

cleanser

•

Wipe with damp soft cloth or nonabrasive sponge, then rinse

with clean water and wipe dry.

Metal Grease Filter:

1. Remove each filter by pulling the spring release handle and

then pulling down the filter.

A ..................

A. Spring releasehandle

2. Wash metal filters as needed in dishwasher or hot detergent

solution.

3. Reinstall the filter by making sure the spring release handles

are toward the front. Insert aluminum filter into upper track.

4. Push in spring release handle.

5. Push up on metal filter and release handle to latch into place.

6. Repeat steps 1-5 for the other filter.