IKEA IH6302YS0 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} IKEA IH6302YS0에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA IH6302YS0 44 페이지. 30"(76.2cm) wall-mount canopy range hood

Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket with

2 - assembly screws provided.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

2. Remove the grease filter. See "Range Hood Care" section.

3. Level the range hood and tighten upper mounting screws.

4. Install 2 - 5 x 45 mm lower mounting screws and tighten.

Install transition on top of hood (if removed for shipping) with

2 - 3.5 x 9.5 mm sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations

only:

1. Fit vent system over transition piece.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

A. Ventcover bracket

B. 2.9 x 6.5 mm screws

C. Deflector

Measure from the bottom of the air deflector to the bottom of

the hood outlet.

A. Air deflector

B. Ventclamp

C. X = length to cut vent duct

D. Ventduct

E. Exhaust outlet

Cut the duct to the measured size (X).

Remove the air deflector.

Slide the duct onto the bottom of the air deflector.

Place the assembled air deflector and duct over the exhaust

outlet from the hood.

Reassemble the air deflector to the duct cover bracket with

2 assembly screws.

Seal connections

with vent clamps.