KitchenAid KICU509 Series 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} KitchenAid KICU509 Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KICU509 Series 12 페이지. 30" (76.2 cm) and 36" (91.4 cm) electric induction cooktop
KitchenAid KICU509 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)

페이지 인쇄

If the house has aluminum wiring, follow the procedure below:

1. Connect a section of solid copper wire to the pigtail

leads.

Prepare Location

1. Decide on the final location for the cooktop.

NOTE: Countertop must be 1

2. If necessary, make cutout in countertop before installing

cooktop. See "Location Requirements" section for more

information.

3. Clean cutout of any remaining dust and debris.

Install Brackets

NOTE: Kit Part Number W10310006 is required for installing the

cooktop into a solid surface or marble countertop. See the

"Assistance or Service" section of the Use and Care Guide for

information on ordering.

To Install Brackets into Marble Countertop:

1. Clean the brackets and cooktop cutout of any dust and

debris.

2. Measure the center line of the vertical sides of the cooktop

cutout.

3. Apply the adhesive provided in the kit to the back side of the

brackets.

INSTALLATION INSTRUCTIONS

" (3.0 cm) to 2" (5.1 cm) thick.

Center line

2. Connect the aluminum wiring to the added section of

copper wire using special connectors and/or tools

designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended

procedure. Aluminum/copper connection must conform with

local codes and industry accepted wiring practices.

4. Position brackets in the center of the vertical centerline and

align the upper edge of the brackets so that they are flush with

the countertop.

5. Push the brackets firmly onto each side of the cooktop cutout

and wait 1 hour for adhesive to dry.

1 h

To Install Brackets into Wood Countertop:

1. Measure the center line of the vertical sides of the cooktop

cutout.

2. Position brackets in the center of the vertical centerline and

align the upper edge of the brackets so that they are flush with

the countertop.

3. Attach the brackets in the cutout with the screws provided.

A. Bracket

B. Screw

Center line