CEP HT63 E 사용자 설명서 - 페이지 2

{카테고리_이름} CEP HT63 E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CEP HT63 E 20 페이지.

Important information

This technical description contains important information for start up and use of the HT63 E
Terminal. Read it carefully before you start working with the HT63 E Terminal.
The warranty will be void should damage occur due to non-compliance with these instructions
for use. We cannot accept any responsibility for consequential loss.
We cannot be held responsible for material loss or personal injury that is due to incompetent
use or non-compliance with the safety instructions. The warranty will be void in such
circumstances.
The HT63 E Terminal contains highly integrated components which can be damaged by
electrostatic discharge if the user would open the housing.
CEP preserves the right to change the included information without notice and doesn't take
responsibility for errors in the document and/or missing information.
Therefore only touch the HT63 E Terminal on the housing or connectors and
avoid touching the components on the board.

Safety Instructions

When using products which are exposed to electric voltage the valid regulations
have to be observed.
Before opening of a device always pull the mains adapter or make sure that the device is
disconnected from the power supply.
You should only use tools on components, modules or devices if they are disconnected from
the power supply and the electric charge, which may still be stored in some components, inside
the device has been discharged.
All cables and wires which are energized and connected to the device, the module or
components have to be checked regularly for any damage of the isolation shield or fractures of
the cables. If the supply cables are visibly damaged the device has to be taken out of operation
immediately until the faulty cable has been exchanged.
When using components or modules it is necessary to strictly observe the specification given in
the corresponding description of these components. If a description for a private end-customer
not clearly states which electric data is valid for a component or a module, how to wire the
2