CEP HT63 E 사용자 설명서 - 페이지 3

{카테고리_이름} CEP HT63 E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CEP HT63 E 20 페이지.

device, which external components or additional devices can be connected or which

parameters these components are allowed to have, a specialist must be contacted.

Before putting a device into operation, it has to be clarified, whether this device or module is

meant for the field of application. In case of doubt ask specialists or the manufacturer of the

device.

Please note that we are not responsible for any errors in usage or connection. Therefore we

cannot accept any responsibility for consequential loss.

Devices which operate with >35 Volt have to be connected by a specialist. Before putting the

device into operation it should be checked that there is no current leakage on the housing.

In case those measurements with the opened housing are necessary, an isolating-transformer

has to be integrated for safety reasons. Alternatively the voltage can be supplied by an

appropriate power supply which complies with the safety regulations. All wiring work has to be

done in a voltage free state only.